1. Table tops are padded with 1/4" foam and upholstered.

2. Elbow and pin pads are made of rubber or high-density foam, upholstered, and screwed or bolted or table top.

3. Sit down table seats are padded with 1/4" foam and upholstered.

4. Table frames should be made of square or round tubing or pipe, and bolted securely to plywood no less than 1/2" thick x 38" wide x a minimum of 5' long in order to maintain stability during competition.

5. All AAA/WAF table top overall dimensions are 26" wide x 38" long with 1" solid, round pegs 6" high from table top, and set in 1" from edge of table. Inside dimensions are 36" long from center of peg to center of opposite peg.

6. All AAA/WAF sit down seat dimensions are 18" square x 18" high from floor to seat top

1. Elbow pads are 7" square x 2" thick, set in 2" from competitor edge of table. The left edge of elbow pad is 16 1/2" from the center of the left peg. Right edge of elbow pad is 12 1/2" from the center of the right peg.

2. Pin pads are 2" wide x 4" tall x 12" long, angled on the table to measure 3 1/4" from the closest corner of the pad to the competitors edge of the table, and 4 1/4" from the center of the left peg to the closest corner of the pin pad.

3. Sit down seats are 18" square x 18" high from floor to seat top, attached to frame edge to be exactly under and in line with table edge.

4. Sit down table seat belt brackets are located to the lower rear of seat frame.

5. Stand up height is 40" from the floor to table top, not including elbow pad.

6. Sit down height is 28" from the floor to table top, not including elbow pad.

Back to Main Page